GIRBAU PB32 Series Installation, Operation And Maintenance Instructions Manual page 10

WARNING!
TRANSPORT, INSTALLATION, INSPECTION, MAINTENANCE, REPAIR OR MODIFICATION
ROUTINES ON GIRBAU EQUIPMENT
1. The actions described in these instructions are strictly reserved for contractually AUTHORISED
TECHNICAL SERVICES (ATS) and personnel who have successfully completed training by Girbau
SA.
2. The company responsible for the Authorised Technical Service accepts full liability for the work done
and any possible consequences that may derive from it.
3. Any actions carried out by personnel who are not authorised by the manufacturer will be considered to
be improper and will result in the automatic voiding of the machine's warranty.
4. The manufacturer will not accept responsibility for any physical and/or material damage caused by
actions performed on the machine undertaken by unauthorised personnel.
5. Do not store or install the machine in areas exposed to the ELEMENTS or where it may be splashed
by water.
6. The room where the machine is located MUST comply with the environmental conditions (air venting,
temperature, humidity, etc.) specified in the technical specifications table. NEVER INSTALL THE
MACHINE IN ENVIRONMENTS where it will be splashed with water or with high ambient humidity.
7. All installations required for the proper operation of the machine MUST be carried out by a duly
accredited Registered Installation Contractors, in compliance with the legal regulations applicable in
the country of use.
8. Once the corresponding operation has been performed, the ATS staff must perform the final machine
inspection.
9. Avoid carrying out any action on the machine without having first read and understood the machine's
Installation and Operating Manuals, paying special attention to the Safety Instructions.
10. In any action that modifies the values of the machine's specifications plate, it should be borne in mind
that:
- It is the responsibility of the ATS to check that the external installation for the machine has been
modified and adapted to the new requirements, particularly to those regarding ducting and
electrical protection.
- It is the responsibility of the ATS to update the specifications plate, in accordance with the new
operation conditions, once the final machine inspection has been performed.
11. Carrying out transport, installation, inspection routines, adjustments, maintenance, repairs, cleaning or
any work on the machines without applying safety measures or having the necessary technical know-
how can lead to ELECTRICAL SHOCK OR SERIOUS ACCIDENTS.
12. When tools designed for specific transport, installation, maintenance and repair routines are available,
their use is compulsory in order to avoid unnecessary risks.
13. Before carrying out any procedures on machines fitted with pneumatic or hydraulic circuits:
- Make the machines COMPLETELY SAFE by following the instructions set out in the corresponding
Manuals or by wedging them with wooden blocks where necessary.
- Bear in mind that working on a component without having previously understood the role that it
performs in the circuit as a whole involves a high risk of suffering a SERIOUS ACCIDENT.
Safety Instructions
10
Code no. 550038
Rev. no. 16/1018