GIRBAU PB32 Series Installation, Operation And Maintenance Instructions Manual page 83

HAND GUARD. The hand guard consists of a swinging motion guard on the front of the machine to prevent the
hands reaching towards the roll.
Pushing or pulling the aforementioned moving guard immediately STOPS the rolls from rotating. The machine
will remain in this state until being operated again.
The hand guard stop is also assigned to operate as a safety stop from any part of the introduction zone.
To activate the hand guard stop:
Press directly on the bottom part of the guard. An audible warning is produced and alarm message appears on
the display.
To deactivate the audible warning press the key STOP.
To continue the operation:
Release the guard by taking the pressure off, checking it returns to its original upright position.
Press the STOP key to deactivate the audible warning and next the START key to renew the operation.
CAUTION!
THE EMERGENCY STOP DEVICE AND THE HAND-GUARD SHOULD NOT BE USED AS A REGULAR
STOPPING DEVICE FOR THE IRONER.
KEEP IN MIND THAT THESES DEVICES:

DO NOT STOP THE INERTIAL MOVEMENT OF THE FANS.

DO NOT CANCELL NOR REDUCE THE TEMPERATURE OF THE MACHINE.

DO NOT DISCONNECT THE IRONER FROM THE ELECTRIC SYSTEM.
Operating and use. Inteli Control
83
Code no. 550038
Rev. no. 16/1018