Preventative Maintenance Program - GIRBAU PB32 Series Installation, Operation And Maintenance Instructions Manual

13.6. Preventative maintenance program

7DAY QUAR ANNUAL
50 h 600 h 2400h
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
CAUTION!
Lubricate only the points described in the section entitled Preventive maintenance program. For any questions
about maintenance please contact the manufacturer.
Maintenance
PROCEDURES RESERVED EXCLUSIVELY FOR CUSTOMER'S TECHNICAL
SERVICES OR AUTHORISED TECHNICAL SERVICES
 Check the contact of the temperature probe and thermostat with the roll
 Check and clean the linen detachment tabs
 Clean the primary air filters (gas heating)
 Check the heating system ignition and combustion (gas heating)
 Clean and check the exhaust filter
 Clean the holes in the vapour suction pipe
 Clean the photocell reflectors and the linen feed sensors. The number of
photocells and sensors varies depending on the models .(PBP51, X20***F
models)
 Clean the protective vents of the roll motor and extraction motor fans
 Lubricate the transmission chains and the rolls' support wheels
 Check the condition of the ironing straps and the pressure roller padding
 Clean the extraction turbine blades and the exhaust ducts
 Clean the inside of the base-frames
 Check the condition of the extractor roller tapes and rubber rollers (PBP51,
X20***F models)
 Clean the steam inlet and condensate return filters (steam heating)
 Check the static pressure at the fan output.
 Clean the pressure switch circuit (PB/PBP51 models, AGA machines only)
REQUEST AN ANNUAL SERVICE FROM AUTHORISED TECHNICAL SERVICES
Check all the functions of the ironer (TEST program)
Check the heating system
Check the power consumption of the roll motor and the extraction motor
Check the power consumption of the electric heaters (electric heating)
Check and clean the burner (gas heating)
Check and clean the premixing fan (radiant burner)
Check the wear and contact of the detachment tabs
Check the ironing straps
Check the feeding straps
Check the output straps (PBP51 model with folder)
Check the pressure roller padding
Check and lubricate chains, sprockets, crown wheel race and roller supports
Check the coupling of the encoder or motion detector
Check linen detachment tapes
Check the condition of the extractor roller tapes and rubbers (model PBP51 with
folder)
Check external protections and electrical grounding
Check the condition of the roll
Checking the wear and contact of the thermostat probe runners
Check the gas tightness of the gas circuit (gas version)
Check the condition of the nuts and bolts
Check that the steam circuit is airtight (steam version), and check for possible
deterioration due to wear
Check the roll motor and extraction motor
Clean all soot and fluff from the inside of the roll and areas of the machine involved
in the extraction of fumes and vapours
142
Code no. 550038
Rev. no. 16/1018