Changing The Type Of Gas - GIRBAU PB32 Series Installation, Operation And Maintenance Instructions Manual

5.3. Changing the type of gas

CAUTION!
THE OPERATION TO CHANGE THE TYPE OF GAS SHOULD ONLY BE CARRIED OUT BY AN
AUTHORISED TECHNICAL SERVICE (ATS).
THE COMPANY RESPONSIBLE FOR THE AUTHORISED SERVICE ACCEPTS FULL RESPONSIBILITY
FOR THE WORK CARRIED OUT AND ANY POSSIBLE CONSEQUENCES ARISING FROM IT.
ANY WORK NOT CARRIED OUT BY PERSONNEL AUTHORISED BY THE MANUFACTURER SHALL BE
CONSIDERED INADMISSIBLE AND AUTOMATICALLY LEAD TO THE LOSS OF THE MACHINE'S
WARRANTY.
THE PERSON FROM THE TECHNICAL SERVICE RESPONSIBLE FOR CHANGING THE TYPE OF GAS
MUST COMPLETELY FILL IN THE MACHINE'S NAMEPLATE FOR CHANGES TO THE TYPE OF GAS
SUPPLIED WITH THE KIT AND AFFIX IT NEXT TO THE MACHINE'S ORIGINAL SPECIFICATION
NAMEPLATE.
BEFORE CHANGING THE TYPE OF GAS, THE TECHNICIAN MUST:
READ AND ENSURE HE/SHE UNDERSTANDS CORRECTLY THE SAFETY INSTRUCTIONS SET OUT IN
THE INITIAL SECTION OF THIS MANUAL.
MAKE SURE THE SITTING OF THE MACHINE AND THE GAS INSTALLATION COMPLY WITH EXISTING
REGULATIONS CONCERNING GAS APPLIANCES FOR THE COUNTRY OR AREA WHERE THE
MACHINE IS TO BE USED.
MAKE SURE THE NEW TYPE OF GAS IS LISTED AMONG THE DIFFERENT TYPES OF GAS REFERRED
TO IN PARAGRAPH 1.2. OF THIS MANUAL. IF IN DOUBT, CONSULT THE COMPANY SUPPLYING THE
GAS.
A FLUE GAS ANALYSER MUST BE USED TO PERFORM THIS OPERATION.
IN ORDER TO ADAPT THE MACHINE TO A NEW TYPE OF GAS, THE CORRESPONDING CONVERSION
KIT SHOULD BE REQUESTED FROM THE MANUFACTURER. CONSULT THE KITS AVAILABLE IN THE
MACHINE'S SPARE PARTS LIST.
Contents of the conversion kit:

Injector

Gas type change label

Information on the location of the details needed to fill in the label in the machine's Instruction manual.
In addition to the conventional tools (spanners and screwdrivers) the following TOOLS AND MEASURING
DEVICES are needed.

TORX T40 screwdriver (radiant burner)

Vernier calliper

Flue gas analyser

Pressure gauge adjusted to the pressure range to be measured
CAUTION!
AFTER CHANGING THE TYPE OF GAS:
 FILL IN AND AFFIX THE GAS TYPE CHANGE LABEL
 CHECK THE MACHINE AS DESCRIBED IN CHAPTER 6 - INITIAL START-UP. INITIAL START-UP.
 ASSEMBLE AND FIX ALL THE MACHINE'S COVERS BACK IN PLACE.
Steps for the connection
62
Code no. 550038
Rev. no. 16/1018