Cleaning The Photocells For The Folder And For The Shut Down Disconnection - GIRBAU PB32 Series Installation, Operation And Maintenance Instructions Manual

13.3. Cleaning the photocells for the folder and for the SHUT DOWN disconnection

Operation exclusively for Models PB, PBP51 and X20
CAUTION! Operation to be performed by the user or by the customer's technical service
Clean the photocells and reflectors on a DAILY basis.
CAUTION
Never perform this operation without having disconnected the power supply.
Before performing this procedure, make sure the temperature of the machine does not present any risk for
handling.
CAUTION!
Dirt on folder and SHUT DOWN disconnection control photocells and reflectors may cause these
devices to malfunction.
Clean off lint and dust residues with a dry cloth. If necessary, use a slightly damp cloth.
Never use any abrasive element or anything that might damage the surface of the photocells or
reflectors.
Steps for cleaning the output reflectors and photocells
(fig.13.2).
The number of linen flow control devices will vary depending
on the model of ironer.
 Turn off the isolator switch controlling the power supply to
the machine.
 Turn the feeder tray upwards until it rests on the feeder
straps.
 Clean the roll linen output photocell signal reflectors A.
 Clean the transmitters B signalling the output of linen from
the roll.
 Place the linen output tray in the work position.
Maintenance
139
Fig. 13.2
Code no. 550038
Rev. no. 16/1018