Information Menu. Introduction And Access - GIRBAU PB32 Series Installation, Operation And Maintenance Instructions Manual

7.7.2. Information menu. Introduction and access

The information menu allows access to information concerning the configuration and to the life of the ironer:
General information. About the ironer model and the control characteristics.

Operation counters. These register the hours of operation and the linear distance covered by the rolls.

Alarm counters. There is a counter associated with each one of the main system alarms that is increased

with the appearance of each alarm.
To move among counters and within each counter use the multi-function keyboard.
There is an option on the SETUP menu that allows setting the value of the different counters at zero. This
operation is reserved for the Authorised Technical Services.
Below, the distinct parameters that make up the INFO menu are listed.
General information. Contents
Machine model. Identifies the ironer model

Program version

A2 board version

A4 board version

Free programs

Updated information

Only machines with gas heating.
Oil probe calibration. Calibration value of the oil temperature control probe.

Fumes probe calibration. Calibration value of the fumes exhaust temperature control probe.

Operation counters
Operating time

Linear Km/miles of operation

Alarm counters
List of controlled alarms
A2 BOARD COMMUNIC. ALM
HAND GUARD ACTIVATION
A2 BOARD RESET
INVERTER COMMUNICATION ALM
GENERAL INVERTER ALM
INVERTER CONFIGURATION ALM
NOT RESETTABLE BURNER ALM
SAFETY THERMOSTAT ALM
GENERAL BURNER ALM
HEATING CONTROL ALM
Operating and use. Inteli Control
HEATING CONFIGURATION ALM
ROLL OVERHEATING ALM
TEMPERATURE PROBE 1 ALM
TEMPERATURE PROBE 2 ALM
TEMPERATURE PROBE 3 ALM
TEMPERATURE FAILURE ALM
ENCODER ALM
EXHAUST PRESSURE ALM
EXHAUST OVERTEMP. MOTOR ALM
FOLDER CONTROL ALM
105
Code no. 550038
Rev. no. 16/1018