GIRBAU PB32 Series Installation, Operation And Maintenance Instructions Manual page 5

Flatwork ironer
Table of Contents

Advertisement

IMPORTANT SAFETY INSTRUCTIONS
CAUTION: To reduce the risk of fire, electric shock or injury to persons when using the machine, follow basic
precautions, including the following:
1.
READ all instructions before using the washer and KEEP them in a prominent location for customer use.
For your safety, do not use the machine without having read the Instruction Manual. KEEP IT in an
easily accessible place in order to resolve any queries, and in case of loss request a new one from your
dealer.
2.
Do not use this machine to handle laundry that has previously been sprayed, washed or impregnated with
petrol, dry cleaning solvents or explosive or inflammable substances. These substances GIVE OFF
VAPOURS that could ignite, explode or break down into toxic and/or highly explosive products.
3.
DO NOT ADD petrol, dry-cleaning solvents, or other flammable or explosive substances to the wash water.
These substances give off vapours that could ignite or explode.
4.
Specific note for machines supplied by water heating appliances. In exceptional conditions, water
heating appliances that have not been used for a minimum period for two weeks can produce hydrogen. If
the water heating appliance has not been used for a time, open the taps and purge the pipes, allowing water
to flow for a few minutes, before using any machine connected to it. This operation will allow the evacuation
of any accumulated gas. HYDROGEN GAS IS EXPLOSIVE, so do not smoke or light any flames during this
operation.
5.
This machine must not be used by children.
Do not allow children to play with or inside the machine. KEEP children under strict supervision when they
are to be found in the vicinity of a machine in operation.
6.
Before removing a machine from service or disposing of it, CONSULT THE INDICATIONS CONCERNING
DISMANTLING. As a general rule, BLOCK all moving parts of the machine and PREVENT THE RISK OF
BECOMING TRAPPED inside.
7.
DO NOT GO INSIDE THE MACHINE OR DISMANTLE ANY KIND OF COVER ON THE MACHINE while it
is working.
8.
Do not store or install the machine in areas exposed to the ELEMENTS or where it may be splashed by
water.
Do not tamper UNNECESSARILY with the machine's controls.
9.
10. DO NOT DISMANTLE ANY KIND OF COVER OR REPAIR OR REPLACE any part of the machine or carry
out any kind of maintenance unless it is properly identified and explained in the user instruction manual.
Even if it is, make sure you understand the instructions properly and have the proper skills and knowledge to
do the job.
11. DO NOT REMOVE any safety device OR MODIFY OR MANIPULATE any component or part of the
machine. DO NOT INSTALL any foreign components inside the machine.
12. Any part of the machine that is replaced may affect its operation and the user's safety. For this reason, USE
ONLY THE MANUFACTURER'S ORIGINAL SPARE PARTS. Failure to comply with this warning can cause
serious accidents, malfunctions and the loss of the machine's guarantee and certifications.
13. Breach of or failure to observe the legislation and regulations covering health, safety and prevention of
workplace risks applicable in the country where the machine has been installed, or actions contrary to
common sense CAN CAUSE personal injury or even death to the user.
14. Utilise the machine only for the uses established by the manufacturer and following the usage instructions
defined in the instruction manuals. Any use not defined in the manuals can cause additional risks. Pay
special attention to information headed DANGER, WARNING and PRECAUTION.
15. The room where the machine is located SHALL comply with the environment conditions (air venting,
temperature, humidity...) specified in the technical specifications table. NEVER INSTALL THE MACHINE IN
ENVIRONMENTS where it will be splashed with water or with high ambient humidity.
Safety Instructions
DANGER!
5
Code no. 550038
Rev. no. 16/1018

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents