Container Rollers Replacement Or Cleaning - Labrie Top Select Maintenance Manual

Loading Container Maintenance
2. Bring the bucket up so the rollers are in the middle of the access trap.
3. Take a 4-foot, 2 in. x 4 in. wood beam, set one end in the rail at least 4 inches below
the rollers. Apply a lever force against the loading bucket to push it towards the body.
This reduces pressure from the rollers against the access cover.
B
E VERY CAREFUL WHILE PERFORMING THIS STEP
DEATH OR SERIOUS INJURY
4. Have someone else open up the access cover while you maintain the bucket pushed
inwards.
5. Slowly step back with the beam to let the rollers swing out of the rail.
FIGURE 1-28. Bucket sliding shoe and rail
6. Repeat the procedure with the beam for the other side of the loading bucket.
7. Clean the rails with pressurized steam or any grease cleaning device.
8. When the desired maintenance is completed, use the beam to push the bucket back
in the rail and have someone put the covers back in place.
1.6.3

Container Rollers Replacement or Cleaning

The container rollers should be checked on a daily basis. Replace them as soon as they
stop rolling properly.
Top Select Maintenance Manual
WARNING
.
. F
AILURE TO DO SO COULD RESULT IN
1-37