Gateway Configura On > Locks > Delete Lock(S) By Serial Number(S) - Alarm Lock ArchiTech Series User Manual

Gateway Configuration > Locks > Delete Lock(s) by Serial Number(s)
In the Gateway Configuration screen, click Locks > Delete Lock(s) by Serial Number(s). Upon selection, a table dis-
playing all physical locks discovered by all Gateways (and/or Expanders) in the Account is displayed. Multiple locks can be
removed from multiple Gateways (or Expanders) by checking their respective checkboxes and clicking Delete. Note: The
removal command is first sent to the Gateway / Expander, then is sent to each selected physical lock to break the relation-
ship between them. Once removed, the lock becomes unassigned and thus able to be re-discovered.
Lock Information
Displays Lock ID number and Lock Profile name. If not
Linked to a Gateway, "Not Linked" is displayed.
Serial Number
Displays the physical lock's unique serial number assigned
and programmed into the lock firmware at the factory.
Each Networx lock is identified in the system by this unique
serial number.
Lock Type
Specifies the model of the Trilogy Networx series locking
devices, such as "PDL6100", "DL6100" or "PL6100".
Description
Description displays the text of the Description field
from the Gateway Configuration screen.
Gateway
Displays the IP address of each Gateway in the Account to
which the lock is assigned.
Location
Displays where the physical lock is assigned (either GW
(Gateway) or Exp-# (Expander number).
Delete (button)
Click to send a delete command to the Gateway /
Expander and to the selected (checked) physical locks.
Unresponsive Lock(s)
If some locks could not be reached and therefore could not
receive the delete command, although the locks will be
removed from the Gateway Lock Table (see previous
page), each lock should be manually reset ("defaulted") to
remove their lock assignments (thus allowing for re-
discovery). See the programming instructions that came
with the lock for the reset procedure.
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE
Unresponsive Gateway(s) / Expander(s)
If a Gateway or Expander could not be reached and
therefore could not receive the delete command, the selected
locks will be removed from the DL-Windows Gateway
database. The Gateway / Expander(s) will be updated later
when the Gateway connection is re-established.
Note: Since the Gateway or Expander could not be
reached, the selected locks could not be reached either.
Therefore, although the selected locks will be removed from
the Gateway Lock Table (see previous page), these locks
must be manually reset ("defaulted") to remove their lock
assignments. See the programming instructions that came
with the lock for the reset procedure.
29