Table of Contents
Advertisement
In the Account List area, click to highlight a Lock Profile, then right-click and select Locate Lock from the menu that appears. Up-
on selection, the Locate Time screen appears where you can set the duration of time (in seconds) for the selected lock to
beep and flash its red LEDs. This option is typically used when you wish to find the physical lock or to confirm the wireless
connection is operational. Note: The physical lock may be located even if it is not Linked to a Lock Profile.
Locate time in seconds
Click the pull-down menu to set the duration of time (in
seconds) for the selected lock to beep and flash its red
LEDs. Up to 255 seconds (4 minutes 15 seconds) can be
selected; default duration is 30 seconds.
OK (button)
Click OK and the physical lock will beep and flash its red
LEDs for the selected duration.
Cancel
Click to exit without requesting the locate Action.
Note: All locks on a Gateway (and/or Expander) may be
sent the locate command (Gateway Configuration > Locks >
Locate ALL Locks on Gateway). For more information,
see page 32.
Right-Click Menu > Update Date / Time in Lock
In the Account List area, click to highlight a Lock Profile, then right-click and select Update Date / Time in Lock from the
menu that appears. Upon selection, a command is sent to the physical lock to update the date and time based upon the
current time and date settings of the PC running DL-Windows.
Right-Click Menu > Take Lock Out of Passage
In the Account List area, click to highlight a Lock Profile, then right-click and select Take Lock Out of Passage from the
menu that appears. Upon selection, a command is sent to the physical lock to change its state to "locked" ("secured"). The
Lock Status screen will automatically appear, displaying the updated Lock Status (" Locked" ).
TIP: For more information about Passage Mode and " Passage" , see OI382.
IMPORTANT:
If the selected physical lock is in an
Emergency state (Emergency Passage or Emergency Lock
Down ), this Take Lock Out of Passage menu item will
be ignored if selected. Lock must be taken out of its Emer-
gency state (Emergency Return to Normal) before it will
accept this menu command.
For more information about Emergency Commands, see
page 42 and page 43.
52
Right-Click Menu > Locate Lock
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE
Hide quick links:
Advertisement
Table of Contents
