Table of Contents
Advertisement
Gateway Configuration > Locks > Locate ALL Locks on Gateway
In the Gateway Configuration screen, click to highlight a specific Gateway in the list, then
click Locks > Locate All Locks on Gateway. Upon selection, the Locate Time screen
opens (shown below) where you can set the duration of time (in seconds) for all locks as-
signed to the selected Gateway to beep and flash their red LEDs. This option is typically
used when you wish to find all of the physical locks or to confirm the wireless connection is
operational. Note: Locks may be located even if they are not Linked to a Lock Profile.
Locate Time in Seconds
Click the pull-down menu to select the time in seconds.
during which all wireless locks assigned to the selected
Gateway will beep and flash their red LEDs. Up to 255
seconds (4 minutes 15 seconds) can be selected; default
duration is 30 seconds.
OK (button)
Click OK and all wireless locks assigned to the selected
Gateway will beep and flash their red LEDs for the
selected Locate Time duration.
Gateway Configuration > Expanders > Discover New Expander(s)
IMPORTANT: For optimal performance, we recommend reading the documentation accompanying the Expanders
for information regarding Expander location guidelines and "Expander Group" dial settings.
After your Gateway has been discovered and added to the Account, up to 7 Expanders may then be discovered and added
to a Gateway. With the Expanders powered, their Group dials set identical to the Gateway and mounted within range of
the Gateway (or another Expander) click Gateway Configuration > Expanders > Discover New Expander(s). The proce-
dure is slightly different from discovering locks or Gateways in that the Gateways / Expanders will automatically determine
the optimal routing pathways between each other, ensuring optimal signal levels.
Note: Be patient; depending on the number of Expanders in your system, this procedure may take up to several
minutes. When complete, the Gateway Expander Table will appear displaying the routing information, status, firmware ver-
sions and signal levels of each discovered Expander.
32
Cancel
Click to exit without requesting the locate action.
Note:
Individual locks may be located (beep and
flash their red LEDs) via a right-click option from the
Account List area (see "Locate Lock" on page 49).
TIP
Discover New Expander(s)
command. This discovery process
will reconfigure the reset Expander
and add it back to its original
location in the Expander Table.
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE
If an Expander is
accidentally reset, don't
worry!
Simply use this Expanders >
Hide quick links:
Advertisement
Table of Contents
