Table of Contents
Advertisement
Gateway Configuration > Locks > View Gateway's Lock Table
In the Gateway Configuration screen, click to highlight a specific Gateway in the list, then click Locks > View Gateway's
Lock Table. Upon selection, the Gateway's internal " Lock Table" is displayed, showing each lock assigned to the
selected Gateway (and/or Expander), and their status as of the last time the table was updated (date and time shown at
bottom left). Use this screen as a tool to verify successful communication with your locks, and their configuration status.
Click Refresh to retrieve and display the latest information.
Lock Profile
Displays name of the Lock Profile Linked to the physical
lock. If not Linked, the text reads "Not Linked".
Serial Number
Displays
the
lock's
programmed into the lock firmware at the factory. Each
Networx lock is identified in the system by this unique serial
number.
Lock Type
Specifies the model of the Trilogy Networx series locking
devices, such as "PDL6100", "DL6100" or "PL6100".
Firmware
Indicates the firmware source code edition currently
residing in each physical lock.
Status
Indicates whether the physical lock is currently Assigned
(was successfully added and configured) or Unable to
Configure (added, but failed to be assigned).
Re-Configure Unassigned Locks (button)
This button appears when any lock in the table was
added but failed to be assigned. Click to re-send the
Config Table to the Gateway thus attempting re-
configuration of all unassigned locks in the table.
Gateway Configuration > Locks > Link / Unlink Lock Profiles
After physical locks are successfully assigned, they must be "Linked" to Lock Profiles (locks not Linked cannot be
downloaded). In DL-Windows, the word "Link" is used to describe the specific action of associating a Lock Profile to the
physical lock assigned to the Gateway / Expander (by serial number). The Lock Type (model) of the Lock Profile MUST
match the assigned lock to which you wish to Link. See page 16 for more information and how to use the Link / Unlink Lock
Profiles screen.
28
unique
number
assigned
Lock Status
Indicates the latest condition of the physical lock (i.e.
"Locked", "Passage" , etc.).
and
unable to be retrieved, "Communication Error" will be
displayed.
LCK Rx (Signal)
Indicates the radio transmission strength, as measured
between the Gateway (or Expander) to the physical lock
(GTW Rx). A higher number indicates stronger signal.
Battery
Displays the status of the battery powering each physical
lock.
Location
Displays where the physical lock is assigned (either GW
(Gateway) or Exp-# (Expander number).
Refresh (button)
Click to retrieve and update the contents of this Gateway
Lock Table screen.
If status is unknown or
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE
Hide quick links:
Advertisement
Table of Contents
