Quick Start - Alarm Lock ArchiTech Series User Manual

1. Install the DL-Windows software (see OI382).
2. Setup your Network connection and install your Gateway (see WI2085). Note: Complete the blue
Gateway ID Card specifying its physical location.
3. Connect the Gateway to the Network, then power up the Gateway (refer to the documentation that
accompanied the device).
4. Start DL-Windows and add a new Account (see OI382).
5. Create Lock Profiles for each physical wireless lock (see OI382). Lock Profiles will be required for
Linking to physical locks after discovery. Note: See Ordering Information on page 4 for supported lock
models.
6. Add Users, create Schedules and set Features for each lock (see OI382). Note: This step may be
performed after the Linking process described in step 13 below.
7. Set Security Password (see page 11). You cannot perform the next step without the Security
Password being set.
8. Click the Gateway Config button (see page 12).
9. Discover Gateways: Click Discover Gateways and Auto Add button (see page 12).
10. Discover Expanders (if applicable): (Refer to the documentation that accompanied the device).
11. Discover Locks: In the Gateway Configuration screen, click to highlight and select the desired
Gateway, set the Number of Locks to Discover, then click the Discover Locks button (page 14).
12. Assign Locks: Select discovered lock(s) by serial number and click Assign (page 14).
13. Link lock(s) to Lock Profile(s) (page 16). In the Link / Unlink Lock Profiles screen:
a. In the Available Lock Profiles field: Click to highlight a Lock Profile.
b. In the Available Lock(s) By Serial Number field: Click to select the desired physical lock (by serial
number) to be Linked to the Lock Profile.
14. "Download" Lock Profile to lock(s) (see OI382).
Congratulations! Locks can now communicate wirelessly. Use the Communication button in the
Lock screen (see OI382), or communicate with multiple locks using the Wireless screen (page
38).
10
Q u i c k S t a r t
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE