Gateway Configura On > Gateways > Manually Add A Gateway - Alarm Lock ArchiTech Series User Manual

Gateway Configuration > Gateways > Manually Add a Gateway
In the Gateway Configuration screen, click Gateways > Manually Add a Gateway. Upon selection, the Manual Gateway
Addition screen opens, where you can manually add a Gateway by adding its unique MAC address.
This screen is typically used to add a Gateway to an Account without needing to perform the Gateway discovery process.
Manually type the unique MAC address of the Gateway in the Gateway MAC Address field, then click Save. The Gateway
MAC address will be saved to the database and added to the Account, and a connection to the Gateway will be attempted.
If the Gateway connection is established successfully, the IP address will be highlighted blue (if unsuccessful, it will be high-
lighted red). When manually adding a Gateway to an Account, keep in mind the following:
● The Gateway you wish to manually add to the Account must be on the network and "Available" (dynamically obtained IP
address and manually reset). See WI2085 for more information.
For a Gateway to be considered "Available", it must be on the network, have a dynamically
TIP
obtained IP address, and manually reset (see WI2085 for reset Gateway procedures).
may also be considered "Available" if it already contains the same Security Password as the Security
Password set for the Account. See section Gateways > Import Gateway and Assigned Lock(s) for
more information.
● The Gateway must be successfully saved and added to the Account before configuring a static IP address or wireless
settings.
● When using the "Internet Gateway Connectivity" feature, uncheck Use DHCP and type the required Remote Configura-
tion settings (WAN Address and Port). See WI2085.
Gateway MAC Address
Carefully type the Gateway's unique 12-character factory
MAC Address located on the square sticker under the bar
code. Each Networx Gateway is identified in DL-Windows by
this unique number. Type all characters of the MAC
Address, do not include dashes or spaces. Note: The
Save button will be enabled after 12 characters are
typed.
Save (button)
Click to manually add the Gateway into the DL-Windows
database. A connection will be attempted and if
successful, the Gateway will be ready for use.
We recommend that when installing a
TIP
Gateway, a blue-colored "GATEWAY ID
CARD" (see image below) be completed.
These blue cards are a useful way to
organize Gateway information, including the
MAC Address and physical location of the Gateway.
~ GATEWAY ID CARD ~
When installing the Gateway, please fill in all infor-
mation on this card. This information will be used
ALARM LOCK
when adding Gateway devices to DL Windows.
Keep this card in a safe place. Do not discard!
G M ________________________________
ATEWAY ODEL
MAC A _________________________________
DDRESS
I L _____________________________
NSTALLED OCATION
___________________________________________
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE
OI357 2/09
A Gateway
25