Emergency > Emergency Return To Normal - Alarm Lock ArchiTech Series User Manual

Emergency > Emergency Return to Normal
Selecting Emergency Return to Normal sends a command to all Gateways (in the selected Emergency Groups) to
immediately revert all assigned locks to the state they were in prior to the initiation of the Emergency command. For example. if
the lock was in an unlocked state due to a Schedule, and a subsequent Emergency Lock Down was initiated, the
Emergency Return to Normal command will revert the lock back to its original unlocked state.
From the Emergency Commands screen, click the Emergency Return to Normal button.
The following Emergency View screen appears:
Once all locks assigned to the Gateway receive the selected Emergency Command, the status will return
"Normal" . In the above image, notice how the status of the second Gateway displays " Unable to verify
lock status" highlighted in yellow. This indicates that one or more locks assigned to the Gateway may
not have received the Emergency Command. Therefore, the Emergency View screen cannot be closed and
the Emergency Command will be re-tried based upon the Set Emergency Attempts selection or until the Abort
Retries button is intentionally clicked.
The following modes will be overridden by an Emergency
Return to Normal Command :
Emergency Lock Down mode
●
Emergency Passage mode
●
W A R N I N G
NEVER use Emergency Commands
to "toggle" Passage Mode, as this
will severely impact battery life.
46
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE