Gateway Configura On > Gateways > Configure / Edit Network Se Ngs - Alarm Lock ArchiTech Series User Manual

Dl-windows for networx v5
Table of Contents

Advertisement

Gateway Configuration > Gateways > Configure / Edit Network Settings
In the Gateway Configuration screen, click to highlight a specific Gateway in the list, then click Gateways > Configure / Edit Network Set-
tings. Upon selection, the Network Configuration screen will open, allowing for Gateway network settings to be configured or
edited. This screen is typically used to configure the Gateway with a static IP address, configure for "Internet Gateway Connectivi-
ty" (Remote Configuration settings) and/or wireless Gateway configuration. Important: For more information about configuring your Gate-
way with a static IP address, "Internet Gateway Connectivity" (Remote Configuration settings), and/or Wireless Network Configuration, see
WI2085.
The following is a brief description of each field as it applies to DL-Windows; see your network administrator for more information if needed.
IP Address Setup
Wireless Mode
Configures the selected Gateway for either wireless or wired
communication with the computer network.
Only or Wireless Only from this pull-down menu. If Wireless
Only is selected, the Wireless Network Security area and the
Wireless Network Configuration area both become active and
available for selection.
DHCP Name
To aid in locating the Gateway on the network, specify a name to
describe the domain name and hostname of the corresponding IP
address assigned to the selected Gateway.
entered here will be used for the DNS configuration (default =
ALARMLCK).
Use DHCP (checkbox)
Use DHCP (Dynamic Host Configuration Protocol) is checked
(enabled) by default.
When checked, DL-Windows allows the
selected Gateway to accept the dynamic assignment of an IP
address by the TCP/IP network. Note that Emergency Commands
may NOT function properly using DHCP. Uncheck Use DHCP to
allow the manual assignment of a static IP address to the selected
Gateway (a warning popup appears that the Gateway may be
unreachable until it is installed on the correct network). The IP
Address, Subnet Mask and Default Gateway fields become
active. Un-checking Use DHCP also activates the fields in the
Remote
Configuration
Connectivity" support (though not required unless using for
Internet access).
IP Address
This field allows the (static) IP address to be manually assigned to
the selected Gateway.
Subnet Mask
The IP protocol makes use of a Subnet Mask to more efficiently
route packets to their correct network destinations.
Default Gateway
This field is the IP address of the physical device, such as a router,
for the current subnet to which you want to be connected. This field
is not to be confused with the IP address of the Alarm Lock
Gateway device installed in the system.
Gateway MAC Address
This field represents the unique 12-digit MAC Address of the
Gateway. This field cannot be edited or changed.
WAN Address (Remote Configuration area)
This field allows DL-Windows to communicate with a Gateway over
a Wide Area Network (Internet).
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE
Select either Wired
The DHCP Name
area
for
" Internet
Gateway
Port (Remote Configuration area)
Default = 10001. Identifies the default Gateway communication
port setting.
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents