Right-Click Menu > Put Lock Into Passage; Right-Click Menu > Update Lock Firmware - Alarm Lock ArchiTech Series User Manual

Right-Click Menu > Put Lock Into Passage
In the Account List area, click to highlight a Lock Profile, then right-click and select Put Lock Into Passage from the menu that ap-
pears. Upon selection, a command is sent to the physical lock to change its state to "unlocked" ("unsecured"). The Lock Status
screen will automatically appear, displaying the updated Lock Status ("In Passage").
TIP: For more information about Passage Mode and " Passage" , see OI382.
IMPORTANT: If the selected physical lock is in an
Emergency state (Emergency Passage or Emergency Lock
Down ), this Put Lock Into Passage menu item will be
ignored if selected. Lock must be taken out of its Emergen-
cy state (Emergency Return to Normal) before it will accept
this menu command.
For more information about Emergency Commands, see
page 42 and page 43.
Right-Click Menu > Update Lock Firmware
In the Account List area, click to highlight a Lock Profile, then right-click and select Update Lock Firmware from the menu
that appears. Upon selection, the standard Windows Open dialog box appears (shown below), allowing you to browse for
the binary ".bin" file containing the lock firmware update.
Select the lock firmware file based on correct Lock Type (model), then click Open to initiate the update process.
The system will check the integrity of the firmware, burn it into the physical lock memory, and reboot the lock. Upon com-
pletion, the Lock Status screen will automatically open. In the Firmware Version field (shown below), verify the updated
firmware version of the physical lock. Note: Though not always necessary, it is recommended to send a full download to
the lock ("Send Profile"). Note: The total time to complete a lock firmware download increases with the addition of
each Expander.
53
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE