Gateway Configura On > Expanders > View Expander Rou Ng Table - Alarm Lock ArchiTech Series User Manual

Gateway Configuration > Expanders > View Expander Routing Table
In the Gateway Configuration screen, select / highlight the desired Gateway from the list, then click Expanders > View Ex-
pander Routing Table to view information about added Expanders. In addition, in this screen, Expanders can be
removed or replaced.
Expander Group No:
Indicates the "Expander Group" dial setting of
the selected Gateway.
Remove Expander (button)
In order to maintain proper routing table integ-
rity, Expanders may ONLY be removed from
the bottom up.
Using the image at right as an example,
"Expander-7" must be removed first before
removing "Cafeteria". Note: The Remove
Expander button is only available for use
with the last Expander in the list (will remain
"grayed-out" for all other Expanders selected).
Replace Expander (button)
This option is used when an Expander needs to be physically replaced with a new
one.
Simply type the serial number of the new Expander into the dialog box that ap-
pears and click "Replace".
Things to consider:
 The new Expander should be powered up and set with the "Expander
Group" number of the old Expander.
 The "parent" does NOT change, therefore the new Expander should be
placed in the same location as the Expander being replaced.
Description
Displays name of Expander. Default name is Expander-#.
Double-click to manually edit the Expander Description
(maximum 30 alphanumeric characters).
Expander
Displays the number assigned to the Expander upon addition
to the Gateway.
Serial Number
Displays the Expanders factory serial number.
Parent
Displays the Expander or Gateway through which the
Expander communicates.
Firmware
Displays the current firmware edition the Expander is
running.
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE
Exp Rx (Signal)
Indicates the radio transmission strength, as measured
between the Gateway to Expander or Expander to
Expander. A higher number indicates stronger signal.
Expander Status
Indicates the last retrieved state of the Expander.
Refresh (button)
Click to retrieve and update the contents of this Gateway
Expander Table screen.
Even if Expanders have not yet been added, but
TIP
you wish to know setting of the "Expander Group" dials
of the selected Gateway, instead of looking inside the
Expander enclosure, simply view the Gateway Expander Table
screen and view the Expander Group No: displayed at the top.
33