MICRO-EPSILON surfaceCONTROL 3D Instruction Manual page 88

Description of the "Evaluation" View
F 3D-View toolbar: Use this toolbar to configure the orientation of the coordinate system in the
3D-View (see Chap. 3.10).
G "Start measurement" button: Click on this button to perform a measuring operation, calculate
the measurement results and display the point cloud and measurement results of the currently
selected measuring program in the 3D-View.
H Results display: The measurement results of the currently selected measuring program are dis-
played. Here, you can select which measured values are to be made available later for calcula-
tion, OK/nOK assessment, logging and output (see Chapter 3.16.8).
I Status bar: Status and error messages are displayed in the status bar (see Chapter 8.1).
1 Input data: Use this selection field to select the input data for the program (see also Chap. 3.16.3).
2 Algorithm: Select the direction in space for determining the extreme points. The following options
are available:
-
X direction: Determine the extreme points in the x direction.
-
Y direction: Determine the extreme points in the y direction.
-
Z direction: Determine the extreme points in the z direction.
3 3D-View: The determined extreme points are displayed as orange points in the 3D-View. The
points that were used to determine the extreme point (green) and the discarded points (gray) are
displayed.
Page 88