MICRO-EPSILON surfaceCONTROL 3D Instruction Manual page 76

Description of the "Data Preprocessing" View
1 -
Input data: Use this selection field to select the input data for the program (see also Chap.
3.16.3).
-
Display: Select wether input data, output data or both is displayed in the 3D-View.
2 Algorithm: Activate the filter and select the filter direction.
Cut-off wavelength [mm]: Use this parameter to specify the cut-off wavelength.
Mode: Use this parameter to define the confidence level:
- High Speed: The confidence level is 90 %.
- Balanced: The confidence level is 95 %.
-
High Quality: The confidence level is 99 %.
Kernel size: In this section the resulting kernel is displayed, which is influenced by the "Cut-off
wavelength" and the "Mode" parameter.
Border mode: Use this parameter in order to adjust the behavior of the profram at the border of
the point cloud:
-
Smooth borders: The border points will also be filtered by extending the point cloud linearily at
the borders about half of the filter size. This is done temporarily.
-
Erode borders: Border points will be removed.
3 3D-View: The filtered point cloud is shown in the 3D-View.
Page 76