SelectNg Tool CondTOn; SettNg The Tool - GRAPHTEC CE6000-120AP User Manual

Setting the Tool
Set the type and offset value of the tool that s used n each of the tool condton numbers.
Condition No.1 applies specifically to use of the pen plunger for the either oil-based ballpoint pen or water based
fiber-tip pen.
Condition No.2 to No.8 applies specifically to the use of the cutter plunger.
Setting Condition No.1 (Pen plunger specific)
Operation
1
Press the [COND/TEST] key n the default screen.
CONDITION settng screen (1/3) s dsplayed.
2
Press the [2] key (TOOL).
TOOL settng screen s dsplayed.
3
Press the [1] key.
CONDITION No. selecton screen s dsplayed.
* Dsplay may vary dependng on the selected condton number.
4
Press the POSITION (
the Tool/Offset you wsh to change.
From here, select "Condton No.1"
5
Confirm the setting and press the POSITION ( ) key
(PREVIOUS) .
CONDITION No. wll get set and return to TOOL settng screen.
) keys to select the Condton No. of
2-31
Supplement
Please select Condton No.1 under "Selectng
the Tool Condtons" when settng up tool
condtons for the pen plunger, and choose
"Condton No.2" to "Condton No.8" when
settng up the tool condtons for the cutter
plunger. For more nformaton, see "2.10

Selectng Tool Condton"

Supplement
It wll return to CONDITION screen wthout
changng the settngs when you press the
POSITION ( ) key (CANCEL).
.
P.2-29