GRAPHTEC CE6000-120AP User Manual page 199

Symptom LCD Display
E01019
E01021
E01022
E05001
E05002
E05003
E05004
E05005
E05006
E05007
Possible Cause
The plotter s defectve.
Load on the motor was too large.
The plotter s defectve.
Load on the motor was too large.
The plotter s defectve.
There was a heavy load on the up and
down functon of the tool carrage.
Data larger than the buffer size cannot be
coped.
There s no data to copy.
Meda vald area to copy s too small.
The push roller s not on the grt roller.
Unable to perform cross cut.
Dstance between the bottom left and top
rght of the AREA settng s less than 10
mm.
Test pattern for the TOOL OFFSET ADJ.
cannot start plottng because the start
poston s at the edge of the meda.
12-11
Solution
Move the object dsturbng the operaton,
and turn on the plotter after turnng t off
once.
Do not use heavy meda.
Move the object dsturbng the operaton,
and turn on the plotter after turnng t off
once.
Do not use heavy meda.
Please clear any obstructon n the up and
down functon of the tool carrage and turn
the power back on.
If the error dsplay contnues to show,
please contact the store where you bought
the product or our Customer Center.
Perform normal cuttng not usng the copy
mode.
Perform normal cuttng by sendng the data,
then use the copy mode.
Use larger meda.
Confirm the copy start position.
Set the push roller on the grt roller.
Unable to separate meda cuts. Check tool
blade and confirm media type.
Perform the AREA settng agan.
Set the start poston nsde the meda.