GRAPHTEC CE6000-120AP User Manual page 70

2.12
Running Cutting Tests
Test cuttng can be performed after makng the tool, speed, force, acceleraton, and perforaton pattern settngs to
ensure that the selected cuttng condtons actually produce the desred cuttng results. Check how far the blade
cuts nto the meda and how the corners are beng cut. If the cuttng results are not satsfactory, adjust the varous
settngs and repeat the test cuttng untl the optmal settngs are acheved.
Cutting Test
Here, you can ether cut one test pattern based on the current values.
Operation
1
Load the meda for test cuttng n the plotter.
2
Press the [COND/TEST] key n the default screen.
In Normal mode, CONDITION screen (1/3) s dsplayed.
3
Press the POSITION ( ) key (CUT TEST).
4
Press the POSITION (
locaton you wsh to perform the test cuttng.
5
Press the [ENTER] key.
1 cut test pattern s cut.
6
Press the [ENTER] key after completon.
CONDITION screen s dsplayed.
7
Press the [COND/TEST] key.
It wll return to default screen.
) key the tool carrage to the
2-41
Supplement
Please choose from Condton No.2 to
Condton No.8 under "Selectng the Tool
Condton". For more nformaton, see "2.10
Selectng Tool Condton"
Supplement
It wll return to CONDITION screen by pressng
the [4] key (CANCEL).
Supplement
Pushng the [POSITION] and [FAST] keys
smultaneously wll move the tool carrage
faster.
CAUTION
When the [ENTER] key s pressed, the tool
carrage wll start movng, so take care not to
cut your fingers.
.
P.2-29