GRAPHTEC CE6000-120AP User Manual page 192

Symptom
• It s cuttng on the grt roller
mprnt.
• Tool condton changes.
• Meda travels tlted.
• It does not become specified
length. (Slght dstance
error)
• "LOAD MEDIA!" s dsplayed
even f the meda s set and
meda set lever s moved up.
Possible Cause
Cuttng wdth s wdened.
Settng of the prorty s set to
PROGRAM.
[ENTER] key s not pressed
after changng the TOOL
CONDITION.
Meda s loaded tlted.
Meda s slppng.
Roll meda s not set properly.
Changng of the hold-down
force of the push roller s not
sutable for the meda.
Meda s slppng.
Dstance adjust value s not
correct.
Meda s close to transparent
and meda sensor makes
false recognton. (Ths may
happen dependng on the
meda.)
Meda sensor malfunctons
wth strong scattered
reflection.
There may be defectve n the
operaton of the meda set
lever sensor.
Solution
Please revert the expand lmt to the
default settng.
Change the settng of the prorty to
MANUAL.
Check the TOOL CONDITION agan.
Reload the meda.
Perform pre feed once and make
mpresson to make t harder to slp.
Set the roll meda properly.
Please set a meda sutable for
changng the hold-down force.
Make the speed slower.
Increase the tool up speed.
Perform feedng.
Perform dstance adjust.
Transparent meda cannot be
detected. DISABLE the meda sensor
and set the cut area when ths knd of
meda s used.
Move the poston of the lght source.
Make s so no drect sunlght shnes.
Contact your sales representatve or
the Graphtec call center.
12-4
Reference
Settng Cuttng
P4-4
Wdth
Prorty of
P10-3
Tool Condton Selecton
(CONDITION PRIORITY)
Settng the Tool
P2-30
Condton
Loadng Meda
P2-7
(Paper)
Settng the
P4-7
number of pre feeds
Loadng Meda
P.2-7
(Paper)
Changng the
P2-18
Hold-down Force
Settng the Tool
P2-30
Condton
Settng the
P4-7
number of pre feeds
Settng the Tool
P7-10
Up Speed
Settng the
P6-10
Dstance Adjust
Enablng/
P9-4
Dsablng the Meda
Sensors (MEDIA SENSOR)
Settng Cuttng
P4-2
Area