GRAPHTEC CE6000-120AP User Manual page 126

6.2
Setting the Step Pass
It may not cut the curved lne smoothly f there s very short lnes n the curve.
It will cut in the units of the specified value when the STEP PASS is used, which allows to control the short lines
wth certan length, resultng to stable rotaton of the blade for hgher cut qualty.
Settng range of STEP PASS s from 0 to 20.
Actual length of the STEP PASS is the value of the STEP PASS multiplied by the distance set in the "STEP SIZE".
"Setting the Step Size (STEP SIZE)"
P.10-4
Supplement
Ths settng wll be saved even f the power s shut off.
The cut mage may not be what you ntended f the set value s too large. It s recommended to set to "1" for normal use.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen s dsplayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) s dsplayed.
3
Press the [3] key (STEP PASS).
STEP PASS settng screen s dsplayed.
4
Press the POSITION (
settng value.
5
Confirm the setting and press the [ENTER] key (SET).
Settng wll be set, and t wll return to TOOLS settng screen (1/3).
6
Press the [PAUSE/MENU] key.
It wll return to default screen.
) key and ncrease or decrease the
6-7
Supplement
Perform the settngs n Normal menu.
Supplement
Settng range s from 0 to 20.
Supplement
It wll return to TOOLS SETTING screen (1/3)
wthout changng the settngs when you press
the POSITION ( ) key (CANCEL).