Microscan VS-1 Getting Started page 28

Chapter 2
The VS-1 Smart Camera in Action - Simple Examples
Adjust the following Acquire properties:
11.
–
–
Highlight Snapshot in the Step Tree (left pane). Right click Snapshot
12.
and click Insert Into. FrontRunner™ displays the Insert Step window.
Click on the Analysis Tools tab. Double click on Flaw Tool to insert it
into the Snapshot.
Highlight Flaw Tool in the Step Tree (left pane) to display the Flaw
13.
Tool properties page.
Adjust the following Flaw Tool properties:
14.
–
–
–
–
In the Setup window, to view Paperclip01.tif, click
15.
FrontRunner™ displays the image Paperclip01.tif and a box, as
shown in Figure 2–13.
2-14 Getting Started with the VS-1 Smart Camera
Picture Mode — Set to Load Images from File.
File List — Click <empty>, and then Add... to display the Open
dialog box. Browse for the files Paperclip01.tif, Paperclip02.tif
and Paperclip03.tif from Windows. They are located at:
C:\Vscape\Tutorials & Samples\Tutorials\HawkEye 1600T\Simple
Flaw Tool
Select Paperclip01.tif, Paperclip02.tif, and Paperclip03.tif. Click
Open.
Note: These files were installed from the installation CD onto your
hard drive when you installed Visionscape. If you installed
Visionscape to a location other than C:\vscape, replace it with the
appropriate drive and directory designation.
Tool Method — Count Edge Pixels
Min Allowed Edge Count — 100
Max Allowed Edge Count — 5000
Graphics Level — Show Details
.
v4.1.0, February 2010