Smd 101 Rear Panel Reset - Extron electronics SMD 101 User Manual

H.264 streaming media decoder
Hide thumbs Also See for SMD 101:
Table of Contents

Advertisement

SMD 101 Rear Panel Reset
The Reset button on the rear panel (see
various modes of operation.
To select different reset modes, use a pointed stylus or small screwdriver to press and hold
the Reset button while the SMD 101 is powered, or press and hold the Reset button while
applying power to the SMD 101.
ATTENTION:
Review the reset modes carefully.
Étudier de près les différents modes de réinitialisation.
Some reset modes delete all user loaded content and revert the device to default
configuration.
Certains modes de réinitialisation suppriment la totalité du contenu chargé de
l'utilisateur et remettent l'appareil en mode de configuration par défaut.
NOTES:
The reset modes close all open IP and Telnet connections and all sockets.
Each reset mode is a separate reset (not a continuation from mode 1 to mode 5).
Reset mode 2 is not available for the SMD 101.
The SMD 101 can also be reset using the web-based user interface (see
Device
For information on resetting the SMD 101 using SIS commands, see
reset
Further details comparing the reset modes and affected configuration settings
and user content are in the reference section (see
page 136).
Mode 1
Press and hold the
Reset button.
Modes 3
Press and hold for
3 seconds.
Modes 4
Press and hold for
6 seconds.
Modes 5
Press and hold for
9 seconds.
Figure 9.
on page 85).
on page 121 of the
Command and Response
RESET
Apply power
to the SMD 101.
Reset LED flashes once.
RESET
RESET
Reset LED flashes twice.
RESET
RESET
Reset LED flashes three
times.
RESET
RESET
Rear Panel Reset Button
figure 3
on page 10) returns the SMD 101 to
Tables.
SMD 101 Reset Summary
RESET
Release Reset button.
Release, then immediately
press and release again. Reset
LED flashes, then goes off.
RESET
Release, then immediately
press and release again. Reset
LED flashes, then goes off.
RESET
Release, then immediately
press and release again. Reset
LED flashes, then goes off.
RESET
SMD 101 • Panels and Cabling
Reset
Absolute
on
13

Advertisement

Table of Contents
loading

Table of Contents