Extron electronics SME 100 Setup Manual

SME 100 • Setup Guide
The Extron SME 100 is a live streaming media encoder that interfaces with DVI, RGB, HDTV,
and standard definition signals for delivering media over IP networks. It features a
three input video and audio switcher, plus buffered loop-throughs for simplified integration into AV systems. The SME 100
uses H.264 / MPEG-4 AVC encoding to output an IP stream over the Internet (or over an intranet) that can easily be decoded
and viewed on PCs or H.264 compatible devices.
Two versions are available: The SME 100 HD (part number 60-1061-01) or the SME 100 SD (part number 60-1061-02).
The only difference between the two versions is that the SME 100 SD only supports standard definition output rates.
This guide provides basic instructions for an experienced installer to set up and operate the SME 100. Installation and service
must be performed by authorized personnel only.
NOTE: See the SME 100 User Guide for complete installation, configuration, operation, and mounting information.
The user guide is available at www.extron.com.

Rear Panel Overview

1
100-240VAC
50/60 Hz
0.5A MAX
a
AC power connector
b
Component, S-video, composite BNC connectors (input 1)
c
Component, S-video, composite BNC buffered loop connectors
d
15-pin HD connector (input 2) with EDID emulation
e
15-pin HD buffered loop connector
f
DVI connector (input 3) with EDID emulation
Installation
Step 1 — Mount the SME 100
Turn all devices off and unplug their power cords. Verify that the SME 100 is disconnected
from the power source. Mount the SME 100 to a rack using the mounting brackets
included with the unit (see image at right).
Step 2 — Connect Input Devices
Connect input devices to at least one of the following connectors.
Connect a video input device to the component, S-video, or composite BNC connectors
z
b
(input 1; ). See the image below to connect the necessary signal format.
Composite Video
1
R-Y Y/
VID
Connect a video input device to the 15-pin HD connector (input 2;
z
Pin 1
Signal
RGBHV R
RGBS R
RGBcvS R
RGsB R
2 4
INPUTS
1 2
Y/
B-Y/
R-Y
VID
C
RGB/R-Y,Y,B-Y/YC/VID
3
DVI-D
3 6
S-video (YC)
1
B-Y/ R-Y
C
Pin 2 Pin 3 Pin 13 Pin 14
G B H V
G B S
G B S
Gs B
5 8
AUDIO
1 2
BUFFERED LOOP
L R L
BUFFERED LOOP
7 9
g
DVI buffered loop connector
h
Audio captive screw connectors (inputs 1 – 3)
i
Buffered loop audio captive screw connectors
j
RS-232 connector
k
Reset button and LED
l
RJ-45 Ethernet connector
Component Video (Y, R-Y, B-Y)
1
Y/ B-Y/ R-Y
VID C
d
). See pin configurations below.
Pin 1 Pin 2
Signal
YUV R-Y Y
S-video Y
Video Vid
3
R L R LAN
RS-232
RESET
ACT LINK
Tx Rx
10 11 12
Rack Mount
Bracket
Y/ B-Y/
VID C
Pin 3 Pin 13 Pin 14
B-Y
C
3
2
1
14
13
1