Installation And Connections; Qc 101 Rear Panel Connections - Extron electronics Quantum Elite Series User Manual

Installation and Connections

QC 101 Rear Panel Connections

The rear panels of the QC 101 E and the QC 101 C are identical except for a label
indicating the model (QC 101 E or QC 101 C).
100-240V ~ 0.5A MAX
A
B
C
D
Figure 59.
A
B
C
D
E
F
G
A A A B B B
OUTPUTS
1
DISPLAYPORT
2
HDMI
50-60 Hz
H H H
AC power connector
DisplayPort output connector
USB connectors
LAN connectors
QC 101 Rear Panel
AC power connector — Connect the supplied IEC power cord between this male
IEC connector and an AC power source.
DisplayPort output connector — (Optional) Connect an external display that
supports DisplayPort to this connector for use when configuring a Quantum
processor using the Quantum Configuration Software.
USB connectors — Connect a mouse and keyboard (or a keyboard and mouse
combination), and a flash drive (if needed), to these two connectors to create and
save Quantum Elite or Connect configuration project files (see the Quantum Control
Software User Guide, available at
Configuration Software).
LAN connectors — These two RJ-45 connectors support 10/100/1000 Base-T.
Connect either of these ports to a LAN or directly to the Control connector on a
Quantum chassis to enable communication with the processor.
NOTE: The QC 100 must be connected to the same subnet as the Quantum
processors.
RGBHV output connector — (Optional) Connect an RGB display to this 15-pin VGA
connector for use when configuring the system using the Quantum Configuration
Software.
Remote RS-232 connector — Connect a control system (such as an Extron IPCP
or IPL Pro Control Processor) to this 3-pole captive screw connector for remote
control of the videowall via RS-232 (see the Quantum Control Software User Guide
for the commands).
Power button — Using a small screwdriver or stylus, press this recessed button
momentarily to safely shut down the controller. Pressing and holding the button for
5 seconds forces a hard shutdown of the QC 101.
Quantum Series Videowall Processing Systems • QC 101 Controller
C C C D D D
USB CONTROL
1
2
LAN 1 LAN 2
VGA output connector
E
Remote RS-232 connector
F
Power button
G
HDMI output connector
H
www.extron.com for details on using the Quantum
E E E F F F
REMOTE
OUTPUTS
RESET
VGA
Tx Rx G
3
RS-232
G G G
70