Smd 101 Rear Panel Reset - Extron electronics SMD 101 User Manual

SMD 101 Rear Panel Reset
The Reset button on the rear panel of the SMD 101 (see
SMD 101 to various modes of operation.
To select different reset modes, use a pointed stylus or small screwdriver to press and hold
the Reset button while the SMD 101 is powered, or press and hold the Reset button while
applying power to the SMD 101.
ATTENTION:
user loaded content and revert the device to default configuration. The
Reset Summary
configuration settings affected by each mode.
NOTES:
• The reset modes close all open IP and Telnet connections and all sockets.
• Each reset mode is a separate reset (not a continuation from mode 1 to mode 5).
• Reset modes 2 and 3 are not available for the SMD 101.
• The SMD 101 can also be reset using the web-based user interface (see
Device
• For information on resetting the SMD 101 using SIS commands, see
page 68 of the
•
Further details comparing the reset modes and affected configuration settings
and user content are in the reference section (see
page 83).
Mode 1
Press and hold
the Reset button.
Modes 4 and 5
Press and hold for
6 or 9 seconds.
Figure 9.
Review the reset modes carefully. Some reset modes delete all
on page 83 provides a summary of the reset modes and the
on page 42).
Command and Response Tables
RESET
Apply power
to the SMD 101.
Reset LED flashes
twice or three times.
RESET RESET
Resetting the SMD 101
Figure 3
on page 9) returns the
section.
SMD 101 Reset Summary
RESET
Release Reset button.
Release, then immediately
press and release again. Reset
LED flashes, then goes off.
RESET
SMD 101 • Panels and Cabling
SMD 101
Reset
Resets on
on
12