Table of Contents
Advertisement
11 TUNING THE CHASSIS
11.14
11.15
50
Handlebar position
M00993-10
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
M00993-11
On the upper triple clamp, there are 2 holes at a distance of
other.
Hole distance A
15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of
the center.
Hole distance B
3.5 mm (0.138 in)
The handlebar can be mounted in four different positions. This allows
the handlebar to be mounted in the most comfortable position for the
rider.
–
1
Remove screws
. Take off the handlebar clamps. Remove the
handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
2
Remove screws
. Take off the handlebar supports.
–
Place the handlebar supports in the required position. Mount and
2
tighten screws
.
Guideline
Screw, handlebar
M10
support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
A
to each
B
from
40 Nm (29.5 lbf ft)
Loctite
®
243™
Advertisement
Table of Contents
