Handlebar Position; Adjusting The Handlebar Position - GAS GAS MC 85 2021 Owner's Manual

10.16

Handlebar position

10.17

Adjusting the handlebar position

Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
On the upper triple clamp, there are 2 holes at a distance of
other.
Hole distance A
The holes on the handlebar supports are placed at a distance of
from the center.
Hole distance B
The handlebar supports can be mounted in four different positions. This
allows the handlebar to be mounted in the most comfortable position
C00248-10
for the rider.
–
Remove screws
handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount and
2
C00249-10 tighten screws
Guideline
Screw, handlebar
support
–
Position handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position handlebar clamps. Mount screws
Guideline
Screw, handlebar
clamp
Info
Make sure the gap widths are even.
TUNING THE CHASSIS 10
15 mm (0.59 in)
3.5 mm (0.138 in)
1
. Take off the handlebar clamps. Remove the
2
. Take off the handlebar support.
.
M10 40 Nm (29.5 lbf ft)
1
and tighten evenly.
M8 20 Nm (14.8 lbf ft)
A
to each
B
Loctite ® 243™
41