Table of Contents
Advertisement
17.4
Adjusting the idle speed
Warning
Danger of accidents The engine may go out spontaneously if the idle speed is set too low.
–
Set the idle speed to the specified value. (Your authorized GASGAS Motorcycles workshop will be glad to help.)
–
Clean the outside of the handlebar and the inside of the grip tube.
Mount the grip tube on the handlebar.
–
Attach the throttle cables to the guide plate and route correctly.
–
Position half-shells
Guideline
Screw, throttle grip
–
1
Slide on sleeve
ment.
S04501-10
Finishing work
–
Check the play in the throttle cable. (
–
Run the engine until warm.
The cold start button is deactivated – A further ¼ turn returns
the cold start button back to the basic position. (
Danger
Danger of poisoning Exhaust gases are toxic and inhaling
them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when
running the engine.
–
Use effective exhaust extraction when starting or run-
ning the engine in an enclosed space.
–
Adjust the idle speed by turning idle speed adjusting screw
Guideline
Idle speed
Tachometer (45129075000)
S03529-11
TUNING THE ENGINE 17
3
, mount and tighten screws
M6
5 Nm (3.7 lbf ft)
and check the throttle grip for ease of move-
p. 117)
1,400 ... 1,500 rpm
2
.
p. 19)
1
.
119
Advertisement
Table of Contents
