Starting Power Of Lithium-Ion Batteries At Low Temperatures; Preparing The Vehicle For Difficult Riding Conditions; Preparing The Vehicle For Rides On Dry Sand - GAS GAS EC 250 2021 Owner's Manual

8.3

Starting power of lithium-ion batteries at low temperatures

8.4

Preparing the vehicle for difficult riding conditions

Info
Use of the vehicle under difficult conditions, such as on sand or on wet and muddy surfaces, can lead to consid-
erably more rapid wear of components such as the drive train, brake system, or suspension components. For this
reason, it may be necessary to inspect or replace parts before the next scheduled service.
–
Seal the air filter box.
–
Clean the air filter and air filter box.
Info
Check the air filter approx. every 30 minutes.
–
Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
» If humidity, corrosion, or damage is found:
–
Clean and dry the connector, or change it if necessary.
Difficult riding conditions are:
–
Rides on dry sand. ( p. 29)
–
Rides on wet sand. (
–
Rides on wet and muddy circuits. (
–
Rides at high temperatures or slow riding. (
–
Riding at low temperatures and in snow. (
8.5

Preparing the vehicle for rides on dry sand

Lithium-ion batteries are far lighter than lead batteries, have a low
self-discharge rate, and have more starting power at temperatures over
15 °C (60 °F). At low temperatures, however, the starting power of
lithium-ion batteries drops to below that of lead batteries.
Multiple starting attempts may be needed. Press the start button for
5 seconds, and wait 30 seconds between attempts. The pauses are nec-
essary so that the heat created can distribute through the lithium-ion
battery and the 12-V battery is not damaged.
If the charged lithium-ion battery is unable to actuate the starter motor
when temperatures are below 15 °C (60 °F), the battery is not faulty, but
402555-01
needs to be warmed up internally to increase its starting power (current
output).
The starting power increases as the battery warms up.
( p. 67)
p. 31)
p. 32)
p. 32)
p. 33)
–
Check the radiator cap.
Value on the radiator cap
» If the indicated value does not correspond to the setpoint value:
M01129-01
PREPARING FOR USE 8
1.8 bar (26 psi)
29