Table of Contents
Advertisement
17.1
Checking the play in the throttle cable
17.2
Adjusting the play in the throttle cable
Info
If the correct routing of the throttle cables has already been secured, the fuel tank does not need to be removed.
–
Check the throttle grip for smooth operation.
–
Turn handlebar as far as possible to the right. Turn the throttle grip
back and forth slightly and determine the play in throttle cable
Play in throttle cable
»
If the throttle cable play does not meet the specified value:
–
Adjust the play in the throttle cable.
Danger
400192-11
Danger of poisoning Exhaust gases are toxic and inhaling
them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when
running the engine.
–
Use effective exhaust extraction when starting or run-
ning the engine in an enclosed space.
–
Start the engine and let it run at idle speed. Move the handlebar to
and fro over the entire steering range.
The idle speed must not change.
»
If the idle speed changes:
–
Adjust the play in the throttle cable.
Preparatory work
–
Remove the seat. (
–
Remove the fuel tank.
–
Check the throttle cable routing. (
Main work
–
Move the handlebar to the straight-ahead position.
–
Push back sleeve
–
2
Loosen nut
.
–
Turn adjusting screw
–
4
Loosen nut
.
–
Turn adjusting screw
–
Turn adjusting screw
S04499-10
the throttle grip.
Guideline
Play in throttle cable
–
Unscrew the adjusting screw
in throttle cable is worsened.
–
Turn adjusting screw
–
4
Tighten nut
–
2
Tighten nut
TUNING THE ENGINE 17
3 ... 5 mm (0.12 ... 0.2 in)
p. 64)
(
p. 70)
p. 78)
1
.
3
in as far as possible.
5
in as far as possible.
3
so that there is play in the throttle cable at
3 ... 5 mm (0.12 ... 0.2 in)
5
until the smooth operation or play
5
approx. two turns further.
.
.
A
.
(
p. 117)
(
p. 117)
117
Advertisement
Table of Contents
