Table of Contents
Advertisement
Info
If the vehicle is operated for a lengthy period with play in the steering head bearing, the bearings and the bearing
seats in the frame can become damaged over time.
12.12
Adjusting the steering head bearing play
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Move the handlebar to the straight-ahead position. Move the fork
legs to and fro in the direction of travel.
Play should not be detectable on the steering head bearing.
»
If there is detectable play:
–
Adjust the steering head bearing play.
–
Move the handlebar to and fro over the entire steering range.
It must be possible to move the handlebar easily over the entire
H01167-01
steering range. There should be no detectable detent positions.
»
If detent positions are detected:
–
Adjust the steering head bearing play.
–
Check the steering head bearing and change if necessary.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
1
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering
head
–
Using a plastic hammer, tap lightly on the upper triple clamp to
avoid stresses.
S04450-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
2
Tighten screw
Guideline
Screw, top steering
stem
Finishing work
–
Check steering head bearing play. (
–
Remove the motorcycle from the lift stand. (
SERVICE WORK ON THE CHASSIS 12
p. 52)
p. 52)
2
and
.
3
.
M20x1.5
12 Nm (8.9 lbf ft)
1
.
M8
20 Nm (14.8 lbf ft)
.
M8
20 Nm (14.8 lbf ft)
p. 58)
(
p. 59)
(
p. 59)
p. 52)
p. 52)
59
Advertisement
Table of Contents
