18 SERVICE WORK ON THE ENGINE
18.7
130
Adding the gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Gear oil must only be topped up when the engine is cold.
–
Remove filler plug
Gear oil
–
Mount and tighten the filler plug together with the O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling
them may result in unconsciousness and death.
401955-11
–
Always make sure there is sufficient ventilation when
running the engine.
–
Use effective exhaust extraction when starting or run-
ning the engine in an enclosed space.
–
Start the engine and check for leaks.
Finishing work
–
Check the gear oil level. (
Preparatory work
–
Park the motorcycle on a level surface.
Main work
–
Detach the foot brake lever spring.
–
Remove gear oil level monitoring screw
S04511-10
–
Remove filler plug
–
Add gear oil until it emerges from the drill hole of the gear oil level
monitoring screw.
Engine oil (15W/50) (
–
Mount and tighten the gear oil level monitoring screw.
Guideline
Screw, gear oil level
monitoring
401955-11
–
Mount and tighten filler plug
–
Attach the foot brake lever spring.
2
with the O-ring, and fill up with gear oil.
0.80 l (0.85 qt.)
Engine oil (15W/50)
(
p. 149)
p. 128)
1
.
2
with the O-ring.
p. 149)
M6
8 Nm (5.9 lbf ft)
2
with the O-ring.