Handlebar Position; Adjusting The Handlebar Position - GAS GAS MC-E 5 Owner's Manual

11.15

Handlebar position

11.16

Adjusting the handlebar position

Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
On the upper triple clamp, there are 2 holes at a distance of
other.
A
Hole distance
The holes on the handlebar support are placed at a distance of
the center.
B
Hole distance
The handlebar holder can be mounted in four different positions. This
M01659-10
allows the handlebar to be mounted in the most comfortable position
for the rider.
–
Remove screws
handlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Place handlebar supports in required position. Mount and tighten
2
M01659-11 screws .
Guideline
Screw, handlebar
support
Mount the left and right handlebar supports in the same position.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
evenly.
Guideline
Screw, handlebar
clamp
Info
Make sure the installed gaps are even.
SUSPENSION SETTING 11
15 mm (0.59 in)
3.5 mm (0.138 in)
1
. Take off the handlebar clamps. Remove the
2
. Take off handlebar supports.
M10 40 Nm (29.5 lbf ft)
1
M8 20 Nm (14.8 lbf ft)
A
to each
B
from
Loctite ® 243™
and tighten
37