18 SERVICE WORK ON THE ENGINE
18.5
128
Checking the gear oil level
Info
The gear oil level must be checked when the engine is cold.
–
Mount throttle valve body
–
Remove the locking piece and position the subframe.
Info
Pay attention to intake flange
–
Join plug-in connector
–
Position and tighten clamps
Guideline
Screw, intake
flange/reed valve
housing
S04510-10
–
Mount and tighten screws
Guideline
Screw, subframe
bottom
–
Remove screws
–
Mount and tighten screws
Guideline
Screw, subframe
S04505-10
top
Finishing work
–
Install the air filter box cover. (
–
Install the fuel tank.
–
Add 2-stroke oil. (
–
Prime the oil pump.
–
Mount the seat. (
–
Install the main silencer. (
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
6
.
5
.
4
of the rear brake light switch.
3
of the throttle valve body.
M6
6 Nm (4.4 lbf ft)
1
.
M8
30 Nm (22.1 lbf ft)
2
.
2
.
M8
35 Nm (25.8 lbf ft)
p. 66)
(
p. 71)
p. 38)
(
p. 124)
p. 65)
p. 69)
Loctite
®
2701™
Loctite
®
2701™
p. 52)