12 SERVICE WORK ON THE CHASSIS
72
Main work
–
Check the throttle cable routing. (
–
Position the fuel tank and fit the two spoilers to the sides in front of
the radiator bracket.
–
Make sure that no cables or throttle cables are trapped or damaged.
S04449-01
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
(All EU models)
–
Position the horn with the horn bracket.
S04447-11
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
S04446-11
–
Remove the wash cap set.
–
Clean the quick release coupling thoroughly with compressed air.
Info
Under no circumstances should dirt enter into the fuel line.
Dirt in the fuel line clogs the injection valve!
–
Spray silicone spray onto a lint-free cleaning cloth and lightly lubri-
cate the O-ring of the quick-release coupling.
Silicone spray (
–
Join quick release coupling
Info
Route the cable and fuel line at a safe distance from the
exhaust system.
–
Attach fuel tank breather hose
–
Plug in connector
S04451-10
p. 78)
1
with the rubber bushing.
M6
10 Nm (7.4 lbf ft)
2
with the collar bushings.
M6
10 Nm (7.4 lbf ft)
p. 151)
3
.
4
.
5
for the fuel pump.