Rs232 Timeout; Xon/Xoff - Honeywell Xenon XP 195 Series User Manual

Flow Control with Timeout: The scanner asserts RTS when it has data to send and
waits for a delay (see
host. If the delay time expires and CTS is not asserted, the device transmit buffer is
cleared and scanning may resume. Default = RTS/CTS Off.

RS232 Timeout

When using Flow Control with Timeout, you must program the length of the delay
you want to wait for CTS from the host. Set the length (in milliseconds) for a
timeout by scanning the barcode below, then setting the timeout (from 1-5100
milliseconds) by scanning digits from the
311, then scanning Save.

XON/XOFF

Standard ASCII control characters can be used to tell the scanner to start sending
data (XON/XOFF On) or to stop sending data (XON/XOFF Off). When the host
sends the XOFF character (DC3, hex 13) to the scanner, data transmission stops.
To resume transmission, the host sends the XON character (DC1, hex 11). Data
transmission continues where it left off when XOFF was sent. Default = XON/XOFF
Off.
Xenon XP User Guide
RS232 Timeout
Flow Control, No Timeout
Flow Control with Timeout
XON/XOFF On
on page 37) for CTS to be asserted by the
Programming Chart,
RS232 Timeout
Two-Direction Flow Control
* RTS/CTS Off
beginning on page
37