Upc-A Addenda; Upc-A Addenda Required; Addenda Timeout - Honeywell HH1800 User Manual

UPC-A Addenda

This selection adds 2 or 5 digits to the end of all scanned UPC-A data.
Default = Off for both 2 Digit and 5 Digit Addenda.

UPC-A Addenda Required

When Required is scanned, the scanner will only read UPC-A barcodes that have addenda.
You must then turn on a 2 or 5 digit addenda listed on
Default = Not Required.

Addenda Timeout

You can set a time during which the scanner looks for an addenda. If an addenda is not found
within this time period, the data can be either transmitted or discarded, based on the setting
you are using for
scanning the barcode below, then setting the timeout (from 0-120 milliseconds) by scanning
digits from the
= 120.
102
2 Digit Addenda On
5 Digit Addenda On
Required
UPC-A Addenda
Programming Chart,
page
Required. Set the length (in milliseconds) for this timeout by
beginning on page 211 of this manual, then Save. Default
* 2 Digit Addenda Off
* 5 Digit Addenda Off
101.
* Not Required
HH1800 User Guide