Switch To Manual Tool Changes - Tormach Automatic Tool Changer Owner's Manual

TECHNICAL DOCUMENT
2. On the ATC tab, select Set TC POS.
Figure 8: Set TC POS button on the ATC tab.
The tool change position is set.

Switch to Manual Tool Changes

From the PathPilot interface, on the Settings tab, select the Manual Tool Change radio button.
The Automatic Tool Changer (ATC) is prevented from making tool changes.
©Tormach® 2020
Specifications subject to change without notice.
Page 42
TD10560: Owner's Guide: M ATC Retrofit for PCNC 770 Series 3 (1220A)
tormach.com