Camera Tilt - LEGRAND vaddio RoboSHOT 12E NDI Complete Manual

Complete Manual for RoboSHOT 12E NDI and RoboSHOT 30E NDI High-Performance PTZ Cameras

camera tilt

Moves the camera vertically.
Synopsis camera tilt{ up [<speed>] | down [<speed>] | stop | get | set}
Options up
down
speed <1 – 20>
stop
get
set <position>
Examples >camera tilt up
OK
>
Tilts the camera up at the default speed.
>camera tilt stop
OK
>
Stops the camera's vertical motion.
>camera tilt set -5 5
OK
>
Tilts the camera 5° down from level at a speed of 5.
Moves the camera up.
Moves the camera down.
Optional: Specifies the tilt speed as an integer
(1 to 20). Default speed is 10.
Stops the camera's vertical movement.
Returns the camera's absolute tilt position in
degrees, as a floating point value between
approximately -30.00 (down) and 90.00 (up).
Note that the range is roughly 30.00 to -90.00 if
Image Flip is selected.
Sets the camera's absolute tilt position in
degrees, as a floating point value between
approximately -30.00 and 90.00 (-90 to 30 if the
camera is configured for inverted operation).
This is the minimum range; individual cameras
may have an additional degree or two of travel
before they reach their physical limits. If the
value is out of range, the camera returns an
error message and no motion occurs. The
speed parameter may be used with the camera
tilt set command.
The camera tilt set command blocks
execution of subsequent commands until the
camera reaches the specified position.
51