System Administration; For Non-Dhcp Environments: Configuring The Device With A Static Ip Address - LEGRAND vaddio RoboSHOT 12E NDI Complete Manual

Complete Manual for RoboSHOT 12E NDI and RoboSHOT 30E NDI High-Performance PTZ Cameras

System Administration

This chapter covers settings for managing the camera as an element of your network.
What controls do you need?
Network settings
Hostname
n
DHCP or static addressing
n
Static: IP address, subnet mask, gateway
n
Access management
Account passwords
n
Guest access
n
Idle session time-out
n
Telnet access enabled/disabled
n
Advanced security settings
n
Time zone and NTP server (source for system time/date)
Information about the camera location
Help desk phone number for end users
Vaddio Technical Support contact information
Diagnostic logs
See Configuring Camera Behavior
behavior.
Note
Vaddio's RoboSHOT series cameras all have very similar web interfaces. Some of the screen shots in this
manual may be from other models in the RoboSHOT series.
For Non-DHCP Environments: Configuring the Device with a Static IP
Address
N
ETWORKING PAGE
Caution
Consult your IT department before editing network settings. Errors in network configuration can make the
camera inaccessible from the network. Do not change DHCP/Static addressing, IP address, subnet mask,
or gateway unless you are very familiar with the characteristics and configuration of the network where you
install the camera.
By default, the camera is set to DHCP and you do not need to configure it with a static IP address.
However, if no DHCP server is available to automatically assign an address, the camera will use the
default IP address of 169.254.1.1. If this is the case, you may need to follow this procedure.
If you install more than one camera on a network that does not automatically assign IP addresses (a non-
DHCP network), follow this procedure to prevent IP address conflicts.
Note
If the camera is currently at an IP address other than 169.254.1.1, skip this section unless you are
instructed to configure the camera with a static IP address.
for information on image adjustments and other items related to camera
19
Go to this screen
Networking
Security
Networking
Room Labels
Help
Diagnostics