Table of Contents
Advertisement
Installing the Wall Mount
The camera is shipped with a wall mount, which can be inverted.
You can install the camera wall mount to a display mount or directly to drywall. If you mount it to drywall,
use wall anchors. A drop-down ceiling mount adapter is also available.
Installing the Camera
Caution
Check your cables. Connecting a cable to the wrong port or using the wrong pin-out can result in
equipment damage and will void the warranty.
1. Slide the camera into the mount. It should be a tight fit.
2. Connect all required cables to the camera.
3. Secure the cable cover to the mount.
About Inverted Cameras
If you use an inverted mount, set the camera's Image Flip mode ON for inverted operation. This orients
the video image correctly and sets the tilt motors to respond appropriately to tilt up and down commands
from the remote, web interface, and connected control devices. Refer to the camera's Complete Manual
Installation Guide for the EasyIP 30 ePTZ AV-over-IP ePTZ Camera
7
Advertisement
Table of Contents
