Configuring Camera Behavior; Setting The Custom Home Position And Other Preset Shots - LEGRAND vaddio RoboSHOT 12E NDI Complete Manual

Complete Manual for RoboSHOT 12E NDI and RoboSHOT 30E NDI High-Performance PTZ Cameras

Configuring Camera Behavior

This chapter covers managing the camera as a part of the room's AV environment.
What controls do you need?
Camera behavior and adjustments
Set or clear presets
n
Set the speed for pan, tilt, or zoom motions
n
Focus the camera
n
Work with color and lighting adjustments (CCU scenes)
n
IR1, IR2, IR3 (Frequency Selection) for controlling up to 3 cameras
n
independently with the remote
IR on/off for enabling/disabling control via the remote
n
Image Flip for inverted camera installation
n
Baud rate for RS-232 serial communication
n
Advanced camera settings
Indicator light – select color scheme, enable/disable, set behavior in
n
standby mode
Codec control mode
n
Read-outs of the camera's hardware switch settings
Streaming settings are managed by NDI software or devices, not on the camera.
Note
Vaddio's RoboSHOT series cameras all have very similar web interfaces. Some of the screen shots in this
manual may be from other models in the RoboSHOT series.

Setting the Custom Home Position and Other Preset Shots

C
AMERA PAGE
The camera's default home position is 0° pan and 0° tilt, at 1x zoom; you can set a different home position.
You can also define other presets for shots that you expect to use repeatedly.
Note
Storing a preset overwrites any information that was previously associated with that preset. The Store
Preset dialog does not show which presets have already been defined. Vaddio recommends renaming
presets when you store them.
Camera
System (DIP Switches and
General tabs)
System (DIP switches tab,
General tab)
System (DIP switches tab)
28
Go to this screen