Table of Contents
Advertisement
Installation Guide for the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera
RoboFLIP 30 HDBT with OneLINK Bridge
999-99800-200 (North America), 999-99800-201
(Europe/UK), 999-99800-209 (Australia/New Zealand)
RoboFLIP 30 HDBT camera
n
Trim ring with mounting screws (shown mounted to
n
the camera)
Tile support brace
n
Cutting template
n
IR remote
n
OneLINK Bridge AV Interface kit – includes:
n
OneLINK Bridge AV interface
o
48 VDC power supply and AC cord set(s)
o
3-position Phoenix-type connectors (qty. 4)
o
USB 3.0 cable, type A to type B, 6 ft (1.8 m)
o
EZCamera RS-232 Control Adapter
o
Installation Guide
n
Features of Interest During Installation
Camera enclosure – 12.1 inch diameter with 15.9 inch flange; height 7.02 inches.
n
OneLINK/HDBaseT connector – For all connectivity and power.
n
Trim ring – Houses the multifunction button. Extends 0.5 inch from the flange of the camera enclosure
n
for a clean installation in a suspended tile ceiling.
Installing the Camera
This section covers:
Connections and pre-installation functional check
n
Selecting the location for the camera
n
Preparing the ceiling
n
Installing the camera
n
Don't Void Your Warranty!
Caution
This product is for indoor use only. Do not install or operate this product if it has been dropped, damaged, or
exposed to liquids. If any of these things happen, return it to Vaddio for safety and functional testing.
Safety Notes
Warning
Follow standard safety practices when using ladders or lifts. Failure to do so can result in injury or death.
2
Advertisement
Table of Contents
