Manual Access And Initial Device Set-Up; Getting The Camera's Ip Address For Manual Access; Accessing The Camera's Web Interface Using Ndi Software - LEGRAND vaddio RoboSHOT 12E NDI Complete Manual

Complete Manual for RoboSHOT 12E NDI and RoboSHOT 30E NDI High-Performance PTZ Cameras
To access the camera's web interface from the Vaddio Deployment Tool:
Select the camera's IP address from any page where it appears. The Vaddio Deployment Tool does one of
these things:
Takes you to the camera's Initial Device Setup page if no admin password has been set.
n
Prompts you to authenticate if the initial device setup has been done.
n
Logs you in to the web interface as admin if you have already authenticated.
n
If the Vaddio Deployment Tool does not find the camera:
Download the latest version of the Vaddio Deployment Tool.
n
Verify that the camera is connected to the network.
n
Be sure you are scanning the right subnet.
n
Check the camera's IP address
n

Manual Access and Initial Device Set-Up

For manual access and initial device set-up, the general process is:
1. Discover the camera's IP address.
2. Access its web interface.
3. Complete the initial device set-up.

Getting the Camera's IP Address for Manual Access

If you are not using the Vaddio Deployment Tool or a Vaddio Device Controller to access the camera's web
interface, you will need to know its IP address.
If you know that your network does not automatically assign IP addresses, skip this section: The
camera's address is 169.254.1.1. You will need to connect your computer's network port to the camera's
network port to do the initial device configuration and network configuration.
If you are not sure, or you know that your network automatically assigns IP addresses, you will
need to be able to view the camera's video output on an HDMI display.
Point the IR Remote Commander toward the camera and press the Data Screen button. The camera's IP
and MAC addresses are displayed. Press the Data Screen button again to dismiss the display.
If the address is 169.254.1.1, the camera is using its default IP address.

Accessing the Camera's Web Interface Using NDI Software

Under the following conditions, you can access the camera's web interface without knowing its IP address:
You have access to a computer using NDI software
n
The camera is deployed on a DHCP network, on a subnet available to the NDI software
n
In this situation, the camera is listed by its hostname in the NDI software as an available device. The
camera's hostname begins with vaddio-roboshot-ndi.
To access the camera's web interface:
1. Open the NDI software if you have not done so already.
2. Select the camera from the list of available devices. The video stream opens, with camera controls
overlaid on the display.
3. Select the Settings icon at the bottom of the camera controls. The camera's web interface opens.
manually.
16