Initial Device Set-Up And System Administration Tasks; Browser Support; Initial Device Set-Up Process Overview - LEGRAND vaddio RoboSHOT 12E NDI Complete Manual

Complete Manual for RoboSHOT 12E NDI and RoboSHOT 30E NDI High-Performance PTZ Cameras

Initial Device Set-Up and System Administration Tasks

Vaddio cameras have a web interface for initial device set-up, administrative control, and operation.
When any Vaddio product is shipped from the factory, there is no admin password and the administrative
controls are not available. This is also true if you restore factory defaults, which returns the device to a "like
new" state.
Initial device set-up includes setting the admin password, and may include additional tasks.
After initial device set-up, the web interface provides password-protected pages for administrative access
to tasks such as configuring network and security settings, customizing device behaviors, and installing
firmware updates. The administrator can configure the operator's page to be password-protected or not.

Browser Support

We have tested this product with these web browsers:
Chrome®
n
Microsoft® Edge and Internet Explorer®
n
Safari®
n
Firefox®
n
We test using the browser version available from the vendor at that time. Other browsers (including older
versions of the ones on this list) are likely to work also.

Initial Device Set-up Process Overview

The sequence of tasks for initial device set-up and system administration differs somewhat, depending on
which method you use.
Ways to access the camera for initial device set-up:
Locate and browse to the camera from the NDI software on your computer.
n
Locate and set up the camera using the Vaddio Deployment Tool – This tool is available as a free
n
download at https://info.legrandav.com/VaddioDeploymentTool. The tool scans the network for Vaddio
devices, lists them by model and IP address, identifies all devices that are not set up, provides the
controls to complete the initial device set-up, and provides links to each device's web interface.
Access the web interface from a Vaddio Device Controller – The touch-panel automatically scans
n
the subnet to locate Vaddio devices. Select the desired device and exit to the device's web interface to
complete the initial device set-up. The process is the same for all products.
Access the web interface directly – The classic method. Discover the camera's IP address and
n
browse to its web interface. The way you discover the IP address depends on the device. The rest of
the process is the same for all products.
12